Chemicals › xt-2000-inc › xt-2000-orange-oil

XT-2000 ORANGE OIL

XT-2000, INC. · Limonene 92% · EPA Reg 71986-1 · INSECTICIDE; MITICIDE

About this product

Active ingredient Limonene 92%
Manufacturer XT-2000, INC.
Category INSECTICIDE; MITICIDE

Full details for XT-2000 ORANGE OIL

EPA registration data Reg. 71986-1 — registry reference, signal word and status.

Applicator discussion

Nothing here is label direction — the label is the law. These are notes from other applicators, moderated before they appear. Check the labeling accompanying the product and applicable state requirements.

Add your experience

Sign in through the portal or Create a free account to post. Comments are reviewed before they appear. Need a website for your pest-control business? See site plans.

According to the label From the product label

These details were extracted from this product's label PDF. The label is the law. Confirm every rate, site, restriction and safety requirement against the label before mixing or applying. Check for a state supplemental label; a product may be restricted or prohibited in a state or site even when a rate appears below. · EPA registration data for Reg. 71986-1 →

XT 2000 is a product used to control Structural Drywood Termites. To treat infested wood, drill 7/64" holes into "kick-outs" at 3"-5" intervals in a "W" pattern to intersect termite galleries. The product is applied via injection for up to one minute into the drilled holes.

Pests covered (4)
Structural Drywood TermiteDRYWOOD TERMITESCARPENTER ANTSWOOD BORING BEETLES
Areas treatable (4)
infested woodWOOD PROTECTION TRT TO EXIST BUILDINGS OR PARTS OF BUILDINGSWOOD STRUCTURAL PARTSDOMESTIC DWELLINGS (INDOOR) (WALL VOIDS)

Application instructions from the label 1

infested wood

Locate termite galleries via visual signs (frass, pellets, blistered wood, kick-out holes, live insects), fiber optic equipment, listening devices, or tapping wood. Drill 7/64" holes into “kick-outs” to intersect galleries. Use a “W” pattern at 3"-5" intervals. Drill holes on opposite sides of 4" x 10" or larger beams. Inject for up to one minute. Avoid splash back or runoff. Plug holes after treatment with wood filler or other non-wood material. Do not drill completely through wood. Avoid electrical wiring and plumbing when drilling.

Target pest
Structural Drywood Termite

Worker safety

PPE required All pesticide handlers (loaders and applicators) must wear long-sleeved coveralls worn over a minimum of short-sleeved shirt and short pants, socks, chemical-resistant footwear, chemical resistant gloves and protective eyewear.

Use restrictions 5